Reliant FVIR GAS WATER HEATER Betriebsanleitung Seite 14

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 13
14
For increased energy efficiency, some
water heaters have been supplied with
two 24” sections of pipe insulation.
Please install the insulation, according
to the illustrations above, that best
meets your requirements.
Typical vertical piping arrangement
Typical horizontal piping arrangement
Hot and Cold Pipe Insulation Installation
Heat Trap
For increased energy efficiency, some
water heaters have been supplied with
factory installed 3/4” NPT heat traps in
the hot outlet line and cold water inlet
line.
These heat traps may require a minimum
of one (1) 90° 3/4” NPT elbow and
may require an additional 90° 3/4” NPT
elbow or a 3/4” coupling depending on
your installation needs. See Illustration
of nipples and heat traps on page 27.
Installing the water heater
For increased energy efficiency, this water
heater has been supplied with a 2 3/8”
section of T&P insulation. Please install the
insulation as shown below.
Typical Side Connect T & P Arrangement.
T&P Insulation Installation
Typical Top Connect T & P Arrangement.
Slip the insulation cover over the T&P
Valve through the center hole and align
the hole in the side with the opening of
the T&P Valve.
Ensure the T&P Valve opening is not
obstructed by the insulation.
Seitenansicht 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare