Reliant FVIR GAS WATER HEATER Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 22)

ELECTRICAL CONNECTIONS/WIRING DIAGRAM

Electrical Connections

Before plugging in the water heater, always make sure:

• The Voltage and frequency correspond to that specified on the

water heater.

• The electrical outlet has the proper overload fuse or breaker

protection.

• Water heater to be located within 6 feet of 120VAC outlet.

• Unit is to connect to a 120VAC electrical supply outlet

(extension cord is not allowed).

• The water heater and the outlet are properly grounded.

• Installed in accordance with prevailing provisions of local codes,

or in the absence of such, National Electric Code, ANSI/NFPS

70 current edition.

Completely fill the tank with water and check all connections for

leaks. Open the nearest hot water faucet and let it run for three

(3) minutes to purge the water lines of air and sediment and to

ensure complete filling of the tank. The Electrical power may then

be turned on. Verify proper operation after servicing.

DAMPER

FLAME SENSOR\IGNITER

GAS CONTROL VALVE\THERMOSTAT

4 3 2 1

3 2 1

6 5 4

FV SENSOR

TEMPERATURE

CUT-OFF SWITCH

FLUE DAMPER

TRANSFORMER

1 2 3

4 5 6

BN - 24VAC

V - 24VAC

BK - 120VAC

WH - 120VAC

BK - 24VAC (HOT)

WH - 24VAC (NEUTRAL)

BK - 24VAC (HOT)

WH - 24VAC (NEUTRAL)

YL - 24VAC

TRANSFORMER

YL 24 VAC

GAS CONTROL VALVE/

THERMOSTAT

FV SENSOR

IGNITER/FLAME

SENSOR

BK - 120VAC

W - 120VAC

YL 24 VAC

BK 24 VAC (H)

WH 24 VAC (N)

TEMPERATURE CUT-OFF

SWITCH

You must provide all wiring of the proper size outside of the water heater. You must obey local

codes and electric

utility requirements when you install this wiring.

This appliance must be electrically grounded in accordance with local codes or, in the absence of

local

codes, with the

National Electrical Code ANSI/NFPA No 70 (current edition) and/or THE CSA C22.1 ELECTRICAL CODE.(LATEST EDITION)

Note: If any of the original wire as supplied with the appliance must be replaced, it

must be replaced with 105

C wire or its equivalent.

ON/OFF SWITCH

END SWITCH

BN 24 VAC

V 24 VAC

FIGURE 23.

Disconnect power before

servicing.

Replacing all parts and

panels before operating.

Failure to do socan result in

death or electrical shock

WARNING

Electric Shock Hazard

Plug into a 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these

instructions can result in

death, fire, or electrical shock.

WARNING

Electric Shock Hazard

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant FVIR GAS WATER HEATER Gebrauchs- und Pflegeanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Warmwasserbereiter & Kessel Reliant FVIR GAS WATER HEATER