Reliant FVIR GAS WATER HEATER Technical Information PDF herunterladen (Seite 8)

Exhaust Vent to

Ouside of Building

Union

Water

Shut-Off

Valve

Water

Supply- Cold*

Expansion Tank

Pressurize to Equal

Supply Water Pressure*

(Relieve water pressure

on the expansion tank

before adjusting air

pressure.)

Temperature-Pressure Relief Valve

with discharge piped to an

adequate drain. Do not cap or plug.

6” Maximum Air Gap

NOTE: Local codes

may vary.

Drain

Gas Control Valve/Thermostat

Recommended setting of 120°F.*

Metal Drain Pan piped to an adequate drai

NOTE: Drain pan diameter must be at lea

2 inches wider than the diameter of the

water heater.

Sediment Trap

(Drip Leg) 3” Minimum.

Gas Supply

To Fixtures - Hot

Air is drawn in for combustion.

Keep area clean and free from

flammables and flammable vapors.

The water heater must be installed according to all local and state codes or in the absence of local

and state codes, the “National Fuel Gas Code”’ ANSI Z223.1(NFPA 54)- current edition.

INSTALLATION OF RESIDENTIAL GAS WATER HEATER

See Labels and

Installation Instructions

and Use & Care Guide

for clearances.

* NOTE: If on a well system the expansion tank should be set to the maximum pressure of the pump tank.

** White-Rodgers® gas control valve/thermostat shown in this figure. The valve may vary according to model and year.

*Massachusett: Install

a vacuum relief in cold

water line per section

19 MGL 142.

Do not cap or plug.

Union

Manual Gas

Shut-off Valve

Untempered

Hot Water

Tempered Water

To Fixtures

Cold

Water

Inlet

Hot

Water

Outlet

Mixing Valve

(Set to 120°F)

Follow the Mixing

Valve Manufacturer’s

Instructions

BASIC INSTALLATION & OPERATION

Figure 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant FVIR GAS WATER HEATER Technical Information Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Warmwasserbereiter & Kessel Reliant FVIR GAS WATER HEATER