Reliant FVIR GAS WATER HEATER Bedienerhandbuch PDF herunterladen (Seite 27)

A. Water at the draft hood is water vapor which has condensed

out of the combustion products. This is caused by a problem

in the vent. Contact the gas utility.

B. *Condensation may be seen on pipes in humid weather or

pipe connections may be leaking.

C. *The anode rod fitting may be leaking.

D. Small amounts of water from the temperature-pressure relief

valve may be due to thermal expansion or high water pressure

in your area.

E. *The temperature-pressure relief valve may be leaking at the

tank fitting.

F. Water from a drain valve may be due to the valve being slightly

opened.

G. *The drain valve may be leaking at the tank fitting.

H. Combustion products contain water vapor which can

condense on the cooler surfaces of the tank. Droplets form

and drip onto the burner or run on the floor. This is common

at the time of start-up after installation and when incoming

water is cold.

I. Water in the water heater bottom or on the floor may be from

condensation, loose connections, or the relief valve. DO NOT

replace the water heater until a full inspection of all possible

water sources is made and necessary corrective steps taken.

Leakage from other appliances, water lines, or ground seepage

should also be checked.

* To check where threaded portion enters tank, insert cotton

swab between jacket opening and fitting. If cotton is wet,

follow “Draining” instructions in the “Periodic Maintenance”

section and then remove fitting. Put pipe dope or teflon tape

on the threads and replace. Then follow “Filling the Water

Heater” instructions in the “Installing the New Water Heater”

section.

LEAKAGE CHECKPOINTSLEAKAGE CHECKPOINTS

LEAKAGE CHECKPOINTS

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Reliant FVIR GAS WATER HEATER Bedienerhandbuch Seite 27