Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 9)

100

101

Octel

Overture 200/300 Serenade 3.0

PB60014–01

  

! "      #



The

Industry Canada label identifies certified equipment. This certification means that the equipment

meets certain telecommunications network protective, operational, and safety requirements. Industry

Canada does not guarantee the equipment will operate to the user

’

s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities

of the local telecommunications company

. The equipment must also be installed using an acceptable

method of connection. In some cases, the company’

s inside wiring associated with a single line individual

service may be extended by means of a certified connector assembly (telephone extension cord). The

customer should be aware that compliance with the above conditions may not prevent degradation of

service in some situations. Communication cables provided by the user to connect to the

telecommunications network must be not less than 26 A

WG copper

Repairs should be performed by Octel Communications Corporation or an authorized representative of

Octel Communications Corporation or the warranty or service agreement could be void. In the event that

this equipment malfunctions, the telecommunications company may request that the equipment be

disconnected.

Users should ensure for their own protection that the electrical ground connections of the power utility

telephone lines, and internal metallic water pipe system, if present, are connected together

. This

precaution may be particularly important in rural areas.



Users should not attempt to make such connections themselves, but should contact the appropriate

electric inspection authority, or electrician, as appropriate. The equipment is installed by trained

personnel.

The

Load Number

(LN) assigned to each terminal device denotes the percentage of the total load to be

connected to a telephone loop which is used by the device, to prevent overloading. The termination on a

loop may consist of any combination of devices subject only to the requirement that the total of the Load

Numbers of all the devices does not exceed 100.

The load number of this product O200 / O300 is 19.

  

This

Class A digital apparatus meets all the requirements of the Canadian Interference-Causing

Equipment Regulations (ICES).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern