Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 498)

100

101

10-6

Installation and Maintenance

olume

Octel Overture 200/300 Serenade 3.0

PB60014–01

Enter

the Answering Mode. Must be either Primary Answer (AX),

Secondary Answer (CX), or Message Center (MX). Determines how the

message server handles the call when that port answers. For further details

on answering modes, refer to the

oduct Description

volume, General

Description chapter, and to the

Configuration

volume, Slots T

able chapter

Line Cards section.

Enter YES or NO to enable or disable message waiting, network message,

and alarm calls. Specifies whether the port may place a call. Provide this

information for each port on the card.



For message waiting notification or alarm outcalls, multiple calls

can be placed simultaneously



Some PBXs require that the same port/extension activate and

deactivate the message waiting lamp. T

o do this, define System

Parameter 106 — LAMP MESSAGE W

AITING POR

, with the

port number to use.

Nonintegrated Systems.

In most cases, allow

all

ports to make outcalls.

When all ports are defined as YES, the message server only makes

outcalls when no more than

of the ports are in use. This leaves ports

available for incoming calls. If NO is defined for any ports, all ports

defined as YES are used for outcalls, even when more than

are in use.

It is recommended that NO for OUTCALL be used only for special

applications.

Integrated Systems.

If eight or fewer ports are configured, the message

server makes outcalls when at least two ports are idle. If 9–32 ports are

configured, the message server makes outcalls when at least three ports are

idle. If more than 32 ports are configured, the message server makes

outcalls when at least four ports are idle.

Enter 1, 2, or 3 to specify that this card is the primary

, secondary

, or

tertiary system clock sync source or N that the card is not used as a clock

sync source.

If no other cards (PIC or other DTIC) have been selected as the primary

clock sync source, enter 1. If another card has been selected as the primary

clock sync source, enter 2. If other cards have been selected as the primary

and secondary clock sync source, enter 3. Otherwise, enter N.

If the card selected as the primary clock sync source has problems (for

example, the clock is lost), the system CPU switches to the secondary

clock sync source. If the secondary fails, the CPU switches to the tertiary

clock sync source. If the tertiary fails, the CPU uses its own internal but

less accurate clock crystal.

Designates the system port number for each port on a DTIC card. The port

numbers are allocated sequentially by the system.

MODE

OUTCALL

SYNC

SYS

1 2 ... 493 494 495 496 497 498 499 500 501 502 503 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 498

Kommentare zu diesen Handbüchern