Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 39)

100

101

INSTALL

1-9

Octel Overture 200/300 Serenade 3.0

PB60014–01

something goes wrong with the message server

, it can call and report the problem. This can be an

on- or of

f-premise number

. Include access codes, if necessary

. Enter a

for a delay after any access

codes you might use. (The length of the delay is determined by System Parameter 28.) Enter an

E for

“expect dial tone.”

Do not

use any spaces.

Question 1. f) asks for the string of numbers to be dialed for the forwarding string and the

cancel-forwarding string when the message server is r

eloading or finished r

eloading.

f) What is the forwarding string, including destination extension,

to be dialed when the system is reloading and cannot accept calls?

(May include: 0–9,*,#, D=DELAY, E=EXPECT DIAL TONE, or F=FLASH,

1–12 chars, empty line = NONE )

What is the cancel–forwarding string, to be dialed when the system

has finished reloading and is ready to accept calls?

(May include: 0–9,*,#, D=DELAY, E=EXPECT DIAL TONE, or F=FLASH,

1–12 chars, empty line = NONE )

While

the Octel Overture 200/300 is reloading after a power failure, the ports can be forwarded to an

alternate answering point. Enter the code that causes incoming calls to ring at the alternate answering

location. If

NONE

is entered, all ports remain of

f hook (busy) when the message server is loading or

reloading.

The second part of this question asks for the cancel-forwarding number to be entered, which allows a

return to the Octel Overture 200/300 when the server is again operational.

Question 1. g) asks for the minimum length for all mailbox security codes.

g) Enter the minimum length for all security codes.

(0–10, empty line = 0 )

The

answer to this question defines the value for System Parameter 144 — MINIMUM LENGTH

FOR SECURITY CODES. The maximum length for a security code is 10 digits.



If this is changed after the initial installation, existing security codes with fewer digits are not

fected until the mailbox holder changes the security code.

Question 1. h) asks for the default security code for mailboxes

that logon using a mailbox

number.

h) For mailboxes which logon via MAILBOX number (NO port/trunk cos attr 106)

enter the DEFAULT SECURITY CODE.

Note: This code will apply to all mailboxes which do not have a security

code defined.

(xx –10 digits, empty line = NONE )

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 39

Kommentare zu diesen Handbüchern