Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 278)

100

101

6-48

Installation and Maintenance

Volume

Octel Overture 200/300 Serenade 3.0

PB60014–01

period

expires, the address is considered to be a network address. For details about

overlapping mailbox addresses and network prefixes, refer to the

Networking

volume, Remote

Analog Networking chapter, Remote Networking Operation, Addressing for Overlapping

Mailbox Addresses, and Network Prefixes sections.

Application

Delays for Call Processing

WAIT AFTER OFF HOOK BEFORE GIVING PROMPT

Application Delay 8 causes a delay between the time the port goes of

f hook and the time the

greeting or system prompt is played.

Use —

If the PBX is slow in sending the speech paths through, it could cause greetings or

prompts to be clipped (only part of the greeting or prompt heard). Modify Application Delay

8 to delay for a longer time before the message server plays the greeting or prompt.

TIMEOUT BEFORE LOOKING FOR RINGBACK OR BUSY

After dialing an extension number

, the message server waits the amount of time specified in

Application Delay 19 before looking for a ringback, busy, or fast-busy tone.

Use —

Some PBXs send a partial ringback or busy tone before starting the ringback or

busy-tone cycle. That would cause the Octel Overture 200/300 to fail, because the partial tone

would not comply with any of the tone windows established in the Application Delay T

able.

Modify Application Delay 19 for a longer time interval.

WAIT LONGER BEFORE LOOKING FOR RINGBACK

Application Delay 87 only works in conjunction with COS Attribute 30 —

EXTENSION IS ON

ANOTHER PBX, WAIT LONGER BEFORE LOOKING AT TONES

After dialing an extension

number

, the message server waits the amount of time specified in Application Delay 87

before looking for a ringback, busy

, or fast-busy tone.

Use —

In some PBX environments, two or more PBXs might be connected through tie lines,

so users on a local PBX could dial an extension number on a remote PBX and be routed

directly to it, without going over the public network. The ringback tone from the distant PBX

is delayed while the PBXs set up the call. W

ithout Attribute 30 and Application Delay 87, the

Octel Overture 200/300 detects the longer silence as an answer and attempts to transfer the

call, which causes a failure. This COS attribute and application-delay combination allows the

Octel Overture 200/300 to wait before looking for a ringback tone when calling certain

extensions.

Application Delays used with Enhanced DTMF In-band Integration

    

This

delay is used as the first delay when looking for dial tone after flash, or whenever E,

expect dial tone, is in a dialing string.

Use —

The message server uses this delay to determine if the PBX has provided dialtone after

flash or whenever E is in a dialing string. If dialtone is not received from the PBX within the

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 278

Kommentare zu diesen Handbüchern