Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 269)

100

101



Commands 6-39

Octel Overture 200/300 Serenade 3.0

PB60014–01

System Forwarding

The

forwarding string entered in System Parameter 45 — SYSTEM-RELOAD FOR

ARD STRING, is

automatically sent if the Octel Overture 200/300 reloads for any reason. During this time, calls are not

accepted for several minutes, while an automatic check is performed on the database. If forwarding

strings are not set up, incoming calls receive a ring-no-answer until the message server is ready

. When

forwarding strings are set up correctly

, the PBX forwards all incoming calls to an operator or attendant

for handling until the message server is ready to receive calls. The following describes the procedure for

testing this feature.

Either the

COURTESY DOWN

(CD x y z)

command, or the

TEST CHANNEL 1

(TE C 1 X Y)

command

to test the forward feature. Y

ou can specify a specific port or range of ports. This command

causes each port to attempt the forward.

When successful, the following message is displayed:

Port #1 Forwarded

All Requested Ports Forwarded

only one port is specified, the Octel Overture 200/300 attempts to forward only that port. If a range is

specified, the message server attempts to forward all ports in the range. If no port is specified, the

message server tries to forward all ports. If a port is successfully forwarded, it is left in the forwarded

state. If a port fails to complete the forwarding, it is left in the NDT state. The Octel Overture 200/300

continues to try to forward all ports specified, until successful or until you press



. T

o review the

port status, use the

P S

command. T

o cancel forwarding, run the System Initialization test, as described

in the following section.

For additional information about using the

CD x y z

command, refer to the System Service Mode

Commands, Courtesy Up/Courtesy Down, section.

System Initialization

When

the Octel Overture 200/300 has reloaded and is ready to handle calls, an initialization sequence

automatically takes place. First, the message server attempts PBX initialization (System Parameter 33 —

PBX INITIALIZE CODE), then attempts the cancel forward string (System Parameter 46 —

SYSTEM-RELOAD CANCEL FOR

ARD-STRING), for each port in turn. When a port fails to

complete the initialization or the cancel forward, the port is left in the NDT state. The message server

attempts to initialize a port every 10 seconds.

Use either the

COURTESY UP

(CU x y z)

command or the

TEST CHANNEL 2

(TE C 1 x y)

command

to test this feature. You can specify a specific port or range of ports. This command causes the

server to attempt initialization and cancel forward for each port in turn.

When the initialization is successful, the following message is displayed:

Port #1 Initialized

All Requested Ports Initialized

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 269

Kommentare zu diesen Handbüchern