Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung PDF herunterladen (Seite 236)

100

101

6-6

Installation and Maintenance

Volume

Octel Overture 200/300 Serenade 3.0

PB60014–01

Command Basic Definition

TE INT x y TEST INTEGRATION

Tells

the integration card to run a link self-test, where

is the slot number, and

is the unit number

. Used only for message servers with integration cards.



This command is not used for DPNSS integration.

T DNET TEST DNET

Use

this command for Digital Networking, to get a quick indication of the

general “health” of the configuration and hardware at the local and remote

cabinets.

TE X x y z TEST FAX

Perform

loopback test on the specified fax channels to verify that the fax

modems can send and receive fax data and to test the TDM bus connection.

Fax-modem data is sent across the Octel Overture 200/300’

s TDM bus, using

one of the fax channels as a sender and the other as a receiver

. When this

transaction is completed, the fax application processor reverses the direction of

the data flow and repeats the transaction. In this command,

is the slot number

is the fax channel, and

is the fax channel. Refer to the

Featur

e Description

volume, Fax Mail Plus chapter

T SNMP TEST SNMP

Octel Overture 200/300 can inform an SNMP manager system when a

qualified hardware error is logged. This command tests the mechanism for an

Octel Overture 200/300 to communicate to an SNMP manager system.

DEX x y Disk

EXer

ciser

ests all hard disk sectors for read errors, where

is the disk number, and

the region number

System Service Mode Commands

Use

the Courtesy Down command,

, to remove from service ports, fax cards, LAN cards, or

integration units or to disable the functionality of the Gateway Link feature. Use the Courtesy Up

command,

, to return them to service.

Use the Shutdown command before LAN Backup and Restore procedures to put the message server in an

f–line mode without physically restarting or reloading the server

. Like Courtesy Down, Shutdown

removes ports, fax cards, and integration units from service, and disables digital and analog networking.

However

, unlike Courtesy Down, Shutdown does not disable the LAN card.

Use the Startup command after a LAN Backup or Restore to bring the message server back online,

removing port forwarding, enabling fax cards, integration units, and analog and digital network

messaging activity



Shutdown is required before restoring prompts and system configuration files. It is recommended

that Shutdown be used before all LAN Restore procedures to prevent callers and mailbox holders

from accessing the server during restore sessions. Such server activity could disrupt the restore

procedure. For LAN Backup, if there is any possibility that voice messages being backed up could

change during the procedure, the server should be in Shutdown mode.

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 667 668

Kommentare zu diesen Handbüchern

Keine Kommentare

Reliant Octel 200 and Octel 300 Message Servers PB6001401 Bedienungsanleitung Seite 236

Kommentare zu diesen Handbüchern